Members Login
    Remember Me  
Post Info TOPIC: vw jetta parking brake malfunction


Status: Offline
Posts: 1
Date: Mar 12, 2011
vw jetta parking brake malfunction

I tried to replace parking brake pads on a 08 passat I input the wrong value first instead of 006 then 007 after the pads were replaced i did 007 first and the parking brake lamp has been flashing since and now when i try the correct sequence the diagun says "vehicle has not this feature" help pl thank youease


Senior Member

Status: Offline
Posts: 105
Date: Mar 12, 2011

Try going back through the precedure and make sure you didn't miss a step.

1. Make sure the electronic Parking brake is OFF to begin with

2. After entering the vehicle manufacturer (VW/AUDI) then choose system “53-

Parking Brake”

3. Select the option “Basic Settings”

4. Enter the number “007” click ok.

The brake calipers will now remain open for the pads to be changed. The EPB light

should be flashing.

Closing the rear calipers once the pads have been changed

5. Re-enter “Basic Settings” under “53-Parking Brake”

6. Select the option “Basic Settings”

7. This time enter the number “006” click ok.

The brake calipers will now close and the EPB light stops flashing.

Function test or rear brake calipers

8. Re-enter “Basic Setting” under “53-Parking Brake”

9. Select the option “Basic Settings”

10. Enter the number “010” click ok.

The brake calipers will now open and close three times.

Adjust the brake pad minimum thickness

11. Re-enter “Basic Settings” under “53-Parking Brake”

12. Select the option “Adaptations”

13. Enter the number “006”

14. Use the + or – to adjust the minimum thickness of brake pads before the warning

lamp illuminates. Values between 3 and 14mm will be accepted.

Page 1 of 1  sorted by
Quick Reply

Please log in to post quick replies.

Create your own FREE Forum
Report Abuse
Powered by ActiveBoard