Diagun will not program sensor ID into ECU(the correct 7 digits).I performed sensor ID Put the 7 # and letters diagun says programed.TPMS light flash for one min the on solid.check current data the sensor ID shows 10 digits with the last (6) with the info i programed.code c2126 i left car on for 30 min air up tire pressure and back down.I dont want to send to dealer.Any help?
Diagun will not program sensor ID into ECU(the correct 7 digits).I performed sensor ID Put the 7 # and letters diagun says programed.TPMS light flash for one min the on solid.check current data the sensor ID shows 10 digits with the last (6) with the info i programed.code c2126 i left car on for 30 min air up tire pressure and back down.I dont want to send to dealer.Any help?
Can you provide the VIN for the vehicle? Also the serial number of your tool.
...check the toyota history section of this forum for previous coroilla tpms issues .....there's info on procedures using jumper wires and other fun stuff ....good luck
I input the sensor ID A3D4435,95A5665,9F32662 AND B0D0665.then i go to the read current data and the registered ID1 IS 0X413D4435 ID2 0X395A5665 ID3 0X39F32662 ID4 0X420D0665.
So i barrowed A TIS scanner. performed the sensor Id learn on all for sensors problem fix.Check the sensor ID with DIAGUN on all 4 sensors found OXOA3D4435,OXO95A5665,OXO9F32662 AND OXOB0D0665.so with that being said the LAUNCH program is not sending the correct info to the ecu.
