LAUNCH TECH USA 1-877-528-6249 SUPPORT@LAUNCHTECHUSA.COM

Members Login
Username 
 
Password 
    Remember Me  
Post Info TOPIC: FOB programming for RKE on a 2005 Jeep Liberty


Newbie

Status: Offline
Posts: 2
Date: Mar 17, 2014
FOB programming for RKE on a 2005 Jeep Liberty
Permalink  
 


I have located the RKE tab under on the VCM.

 

But when trying to program the FOB the scan shows that the module is not on programming mode.

 

Does anybody know how to enter into programming mode?

Would the following do the trick???

 

Program Method D (For use with AB vehicles not equipped with VTSS only)

1. Locate the dark green program enable wire connected to pin #1 of the 16-way

data link connector under the left side of the instrument panel.

2. Connect the program enable wire terminal to a good ground.

3. Insert the key into the ignition and turn the ignition switch to the ON position. The power

locks will cycle (Lock and Unlock) indicating that program mode has been entered.

4. Using the transmitter to be programmed, press either [LOCK] or [UNLOCK]. The power

locks will cycle indicating the transmitter has been programmed successfully.

5. Repeat step 4 to program additional transmitter.

6. Disconnect the program enable wire from ground to exit program mode.

7. Turn the ignition to the OFF position and remove the key

 

Thanks.

 

Charlie.

 



__________________
Page 1 of 1  sorted by
 
Quick Reply

Please log in to post quick replies.



Create your own FREE Forum
Report Abuse
Powered by ActiveBoard